The standard plastic handle 365.0 has a classic dog-shape. We manufacture it in three dimensions - 137mm, 165mm and 192 mm. All versions can carry the same weight, but the smaller one fits only two fingers, the middle version a female hand and the big version - a male hand. When the handle is holstered its end slide inside the box - usually between top flaps of cardboard
The handle is mounted to the top side of the box through slots perpendicular to its length.
It can be supported by a reinforcing plate 991.0 which distributes the weight of the packaging on bigger area. This might be helpful if the box is made of thin cardboard and the weight of the content is close to the limit.
Most important handle dimensions are shown in the drawing, production tolerances may change these values to some extent - e.g. depending on the material properties. If you want to know the tolerances please contact us.
Dimension | Value | Dimension | Value |
---|---|---|---|
A: | 137mm or 165mm or 192mm | F: | 5mm |
B: | 129mm | G: | 4mm |
C: | 92mm or 120mm or 150mm | ||
D: | 23mm | ||
E: | 11mm |
This handle is made of original Polyethylene material. Our raw material suppliers are carefully chosen and always provide us with the spec sheets of the materials.
The spec sheet contains product dimensions, packaging cut-out dimensions, and all other parameters contained in this webpage- all in a compact PDF format.
Several products that are commonly used with this handle or simliar to it.