This smaller form factor handle is alternative to 169.0-155mm with a different slot needed in the cardboard flap. Thanks to its narrow ends can be used in packagings were the available space is small. It is also best suited for the easiest installation.
The handle is mounted to the top side of the box through slots parallel to its length - as opposed to our handle 169.0.
It can be supported by a reinforcing plate 882.1 which distributes the weight of the packaging on bigger area. This might be helpful if the box is made of thin cardboard and the weight of the content is close to the limit.
Most important handle dimensions are shown in the drawing, production tolerances may change these values to some extent - e.g. depending on the material properties. If you want to know the tolerances please contact us.
Dimension | Value | Dimension | Value |
---|---|---|---|
A: | 156mm | F: | 12mm |
B: | 147mm | ||
C: | 100mm | ||
D: | 12mm | ||
E: | 25mm |
This handle is made of original Polyethylene material. Our raw material suppliers are carefully chosen and always provide us with the spec sheets of the materials.
The spec sheet contains product dimensions, packaging cut-out dimensions, and all other parameters contained in this webpage- all in a compact PDF format.
Several products that are commonly used with this handle or simliar to it.